Florida rehab costs

New floors for a Florida flip or rental

Flooring is the line buyers see first and the one tenants wear out fastest. Most of the cost difference between two flooring jobs comes from what is under the old floor, not the product going down.

Planning range · typical single-family house$6,000 to $20,000

Pull up a corner before you price

Lift a carpet corner in a closet and look at what the house is sitting on before you decide what flooring costs. Many Florida houses built from the 1950s through the early 1970s have terrazzo under carpet or vinyl. Terrazzo can be ground and polished into a durable, attractive floor that buyers in some neighborhoods actively want, and it may cost less than covering it. Other houses reveal old 9-inch square tiles and black mastic, which can contain asbestos and should be tested before anyone grinds or scrapes them.

Tile over tile is another common discovery. A previous flipper may have laid ceramic over old vinyl, which adds height and makes removal slower. Raised wood-frame houses may have original hardwood under carpet, sometimes salvageable, sometimes rotted near bathrooms and exterior doors. Each of these finds changes the price and the schedule, which is why the flooring line on a rehab estimate should always be confirmed on a walkthrough.

Choosing a floor for the exit

For flips, use one continuous hard floor through living areas and bedrooms where the comps support it, because unbroken flooring photographs larger and reads as more updated. For rentals, choose a vinyl plank with a thick wear layer and a click system you can repair plank by plank, and buy extra boxes from the same lot for future patches. Leftover boxes stored in the garage save you from mismatched floors at the next turnover.

  • Waterproof vinyl plank: the default for most Florida investment houses, quick to install, comfortable and forgiving of small slab imperfections.
  • Porcelain or ceramic tile: very durable and expected in some coastal and older markets, with higher labor and longer install time.
  • Polished terrazzo: a strong choice when it is already there and in repairable condition.
  • Carpet: inexpensive and sometimes acceptable in bedrooms on rentals, but a frequent turnover cost.
  • Engineered wood: rarely worth it on slab houses in humid climates, and seldom expected by investment buyers.

Slab prep is half the job

Most Florida houses sit on concrete slabs, and the slab decides how well new flooring performs. Vinyl plank needs a reasonably flat surface or the locking joints flex and separate. Tile needs a flat surface and a sound bond, or it cracks and hollows. Grinding high spots, filling low areas with self-leveling compound and repairing cracks are prep steps that installers price separately, and they are the source of most flooring change orders.

Moisture matters too. Slabs in older houses may lack a vapor barrier, and a slab that stays damp can ruin adhesive-down products or trap moisture under plank and cause odor. Ask the installer whether they test slab moisture and what underlayment they recommend. If the house had a drain leak under the slab, finish that repair and let the patch cure before anyone lays flooring.

Measuring square footage the right way

Flooring bids are priced on installed square footage, which is not the same as the heated area on the property record. Closets, hallways and bathroom floors may or may not be included, and installers add a waste factor for cuts, which is larger for diagonal tile and herringbone patterns. Measure each room yourself or ask each installer to list rooms and footage so you can compare bids on the same area.

Prices vary by county, the product selected, permit requirements and installer availability, and the per-foot material price is only part of the story. Removal and disposal, slab prep, baseboard replacement, quarter round, transitions at doorways, stair nosing on two-story houses and moving appliances all add to the total. A bid that looks low on price per foot often leaves several of those out.

Floors go in late and draw late

Install flooring after drywall, ceiling texture and most painting, and after cabinets in kitchens where the floor runs under them or stops at the toe kick, depending on your installer’s method. Floors that go in early get scratched by every trade that follows. If schedule pressure forces an earlier install, cover the floor with protection board and tape seams, and make covering the floor someone’s job.

On Think Off Market listings, flooring is usually its own line in the rehab estimate, sized by the lender for the scope it expects. Think Private Lending funds the approved rehab budget in draws as work is completed and verified, alongside up to 90% of the purchase price, so flooring typically draws near the end of the project once installation is complete. Photograph each room before baseboards go on so the draw inspection and your records show the full install.

Flooring bid details worth asking

Ask each installer to name the product, wear layer thickness, underlayment, prep work included, rooms covered, baseboard and trim scope, and who handles appliances and toilets. Ask whether they test for asbestos when they encounter old tile or mastic, or whether that is on you. Confirm insurance and check finished work. Straight runs, clean transitions and tight cuts around door casings are the details buyers notice when they walk the house, and tenants notice when planks start separating six months later.

Settle the bathroom question in the bid as well. Some investors run vinyl plank through bathrooms for a continuous look, while others tile bathrooms and use plank everywhere else. Either works, but the bid has to say which, and it has to say who pulls and resets toilets and how the floor meets the tub or shower curb. A vague answer here becomes a gap at the toilet flange or a raw edge at the tub, and both show up on the buyer’s inspection report.

Finally, settle on a single installer for every room if you can. Two crews means two sets of transitions, two interpretations of where the floor stops and two people to blame when something lifts after the first humid summer. One crew owns the whole floor and the whole result.

Straight answers

Questions investors ask

How much does new flooring cost on a Florida investment house?

For a typical 1,200 to 2,000 square foot house, $6,000 to $20,000 is a reasonable planning range. Vinyl plank on a flat slab sits at the low end. Tile, heavy slab prep, removal of tile over tile and asbestos abatement push it up.

Should I polish terrazzo or cover it?

If the terrazzo is in repairable condition and the comps include houses with it, polishing often costs less than covering and appeals to many buyers. Badly cracked or patched terrazzo is usually covered.

Is vinyl plank good for Florida rentals?

Waterproof vinyl plank with a thick wear layer is the most common choice for Florida rentals because it handles humidity, cleans easily and can be repaired plank by plank.

See the addresses. Walk the houses. Close with the money already lined up.

Buyer access is free. Tell us what you buy and where, and we will open the full listings: addresses, photos, access instructions and the financing terms behind each one.