Patch, skim or replace the drywall
Most investment houses need drywall patching, not replacement. Plumbers, electricians and HVAC installers all cut openings, and old anchors, doorknob holes and water stains add more. A good drywall finisher patches, tapes, matches the existing texture and leaves walls ready for primer. When walls are rough from layers of old paint and repairs, a skim coat over large areas costs more labor but gives a far better finished wall.
Replacement makes sense where drywall is wet, moldy, termite damaged or crumbling, which is common under windows, around tubs and along exterior walls after long-term leaks. In houses where a kitchen or bathroom is gutted, new drywall in those rooms is part of the remodel. Full-house replacement is rare and usually tied to flood damage or the defective drywall problem described below, both of which belong in different budget lines.
Checking 2001 to 2008 houses for problem drywall
Some Florida houses built or renovated between roughly 2001 and 2008 used imported drywall that gives off sulfur gases. The signs are a rotten-egg or sulfur smell, blackened copper wiring at outlets and ground wires, and repeated AC evaporator coil failures. Remediation generally means removing the drywall and replacing affected wiring and components, which is a much larger project than a paint and patch job and is not covered by the range on this page.
Before you buy a house from that era, look at a few outlet ground wires, check the AC service history if the seller has it, and ask an inspector who knows the issue to look. Some drywall carries printed markings on the back that can be seen from the attic. If the house has the problem, price the remediation separately and make sure the after-repair value still supports the deal.
Popcorn ceilings and older textures
Acoustic popcorn ceilings were common in Florida houses through the 1970s and into the 1980s. Buyers see them as dated, and many flippers remove them. Before scraping, test the material for asbestos, which was used in some ceiling textures of that era. If the test is positive, removal requires a licensed abatement contractor, which changes the cost considerably, and covering the ceiling with new drywall becomes a reasonable alternative.
If the test is negative, removal means wetting, scraping, skim coating and re-texturing or leaving a smooth finish. It is messy and labor heavy, so do it before flooring goes down. Knockdown and orange peel textures are common on Florida walls and ceilings, and matching existing texture on patches is a skill. Ask for photos of a finisher’s matched patches before you hire them.
Paint choices for flips and rentals
Prices vary by county, the paint line chosen, any permit requirements tied to related work and how busy painting crews are, so expect quotes to differ. Labor is most of the cost. Empty houses paint faster, and spraying an empty house before flooring goes in is much faster than brushing and rolling around finished floors and fixtures.
- Use one neutral wall color throughout a flip so every room photographs as part of the same house.
- Paint ceilings flat white to hide imperfections and brighten rooms.
- Use semi-gloss on trim and doors so they wipe clean and look crisp in photos.
- On rentals, choose a scrubbable eggshell or satin wall finish your manager can touch up between tenants.
- Record the exact color name, sheen and store for every surface and leave the list in the property file.
- Use a mildew-resistant paint in bathrooms and laundry rooms, where Florida humidity concentrates.
Last trade in, first trade judged
Drywall should follow every trade that opens walls, which means after rough electrical, plumbing and HVAC inspections pass. Primer and the first coat of paint often go on before flooring and cabinets, with a final coat and touch-ups after other trades finish. Plan for touch-ups, because every trade that follows leaves marks. A short final punch list with the painter is cheaper than a buyer’s agent pointing out scuffs in photos.
On Think Off Market, each listing’s rehab estimate includes interior paint and drywall as its own line, and Think Private Lending funds the approved rehab budget in draws as work is completed and verified. Paint and drywall usually draw near the end of the job. Keep before and after photos of each room, because a finished paint job is easy to verify, and photos make the inspection quick.
What a painting bid should include
Start the conversation with the patching scope, because it changes the paint price more than the paint does. A painter quoting a clean, recently painted house and a painter quoting a house with every wall patched are pricing different jobs. Walk the house with each painter and agree on which walls need a skim coat, which ceilings have stains and which doors are being replaced.
A painting bid should name the paint line and sheen for walls, ceilings, trim and doors, the number of coats, the primer used over patches and stains, whether closets and garage walls are included, and who handles drywall repair. Water stains need a stain-blocking primer or they bleed through new paint. Ask whether the painter caulks trim gaps and fills nail holes. Small details like caulked baseboards and clean cut lines are what make a house look professionally finished.
Ask how the painter protects floors, cabinets and fixtures if they paint after those are installed, and who cleans overspray off windows and hardware. Ask whether doors are painted on both sides and on the edges, and whether the interior of the garage, the laundry area and the closets are in scope. Those small rooms are where cheap bids save time. A buyer opening a closet to a dirty, unpainted interior gets a different impression than one who sees the same fresh white as the rest of the house.